OKAY!!.... so....I get the 14HP AQS set back in a tractor (a 1200 GD) get her up and running around a bit and ran total af may be an hr or hr & 1/2, retorque the head and run some more.....It's pumping a lot of oil out the breather!!! )(*&%*^%(*&)&)_!! and really smokes bad when under a load ( I pushed a few piles of snow)
I really hadn't planned on doing this the whole route if not need be, but had hoped maybe I could luck out here....NOT!!
What would be the best next step?? fill it half and half oil/MMO ???, half and half oil/tranny fluid?? and run some more in hopes of freeing up "stuck rings" maybe or should I just bite the bullet and go for teardown at least to the point of hone and ring job. What would you guys suggest here??
Thanks in advance!
Fumed in Iowa
Dave S.