Archive through September 01, 2015

[kmcconaughey]

John, I believe he is referring to the pin on the "attaching plate" that mounts to the rockshaft. There is no bushing on that end.

From the install instructions for a 1x6/7.

Doug, if you can wait a few hours, when I get home from work today I'll see if I can find (not sure where I hid it) the uninstalled narrow frame 3 point setup that I have.

 

[danderson]

I have the bushing in the casting end. The question is on the rockshaft end. I'm wondering if the hole is supposed to be a larger diameter than the pin.

 

[cstouffer]

i have a load tester at work, ill get it charged and throw it on some load. thanks for all the help guys and ill keep you all updated on whats going on.

 

[jmacdonald]

I have would should be a non problem, but I can't get by it.
I am trying to attach a 48" mower deck to a 125. I have the deck attached to the sub frame, but the main drive belt from the PTO to the center pulley is banjo tight. I cannot loosen the adjustment any more. I am using what I think is the correct belt an IH-489397-R3.
I have looked at the 3 versions of the manuals on the topics page (they all appear to be the same to me). I have also searched the forum. The only thing I see different is on my 125 I have two bolts on each side of the quick hitch to bolt it to the frame whereas the manuals just show the one quick hitch bolt. I have taken some photos hoping somebody will notice something obvious I have not. I have temporarily disconnected the disconnected the two lift links in the photo.

 

[jmacdonald]

Two more

 

[digger]

James M.
Is what you have look like either of these 2?
Notice the many differences in the 2, which would make a difference hooking it up.
From the Parts Look Up.

 

[kmcconaughey]

Doug, sorry it took so long, finally remembered that the lift bar was in my sand blasting cabinet waiting to be blasted. It's only been there for ~6 years...

I believe it should be a fairly tight fit, my setup is. Note, the attaching plate that I have is a reproduction one that I purchased from forum member Mike Masheris, the bar is an original used one.

 

[kmcconaughey]

James, what do the runners look like on the 48" deck, round or flat? Can you post a photo that shows more of the deck details?

 

[jmacdonald]

Charlie mine looks like the top photo you posted.
Kraig I will take some more photos in The AM and post them.
Thanks to both for helping.

 

[danderson]

Thanks Kraig. My pin is the same 5/8" diameter. I'd say my bar is worn. I'll put a bushing in it.