• FIRST AND LAST NAMES ARE REQUIRED WHEN REGISTERING
IH Cub Cadet Tractor Forum

Help Support IH Cub Cadet Tractor Forum:

D
Reaction score
237

Latest activity Postings About

    • D
      dfrisk replied to the thread Finally after 7 years a QA 36.
      Donald - One more thing I bet Mike will agree with me on, look over the short little jackshaft and the "H" shaped aluminum casting to...
    • D
      dfrisk replied to the thread Saving a Farmall M.
      JP - Dad told me the M&W hand clutch was, " The Best way to make an M a 2-bottom tractor." It forced all the horsepower to the drive...
    • D
      dfrisk replied to the thread Finally after 7 years a QA 36.
      Donald - Kraig is exactly right, that's a really clean QA36, not missing many if ANY parts. Probably didn't get a lot of use. A 10 hp...
    • D
      Hmmmm, I almost bit the bullet and bought an Agri-Fab sweeper this fall, glad I didn't now, I really don't need another project. The...
    • D
      dfrisk replied to the thread Fuel sediment bowl elimination.
      Yep, 1/4 turn gas valve, and the BEST in-line filter I've found is a Mr. GASKET see-thru filter, clear PYREX cylinder, Vinton o-ring...
    • D
      There " MAY BE" a situation that 4-link chains may be better than 2-link chains, but I haven't found that situation yet, My first set of...
    • D
      dfrisk replied to the thread SZ 60 zero turn plow.
      Wow, Your TANK is identical to mine except mine is an LZ, lever steer vs SZ steering wheel steer. I had my choice of 54 or 60 inch deck...
    • D
      dfrisk replied to the thread My Free Compressor.
      My current compressor is a Porter-Cable 2-stage 2 cylinder 80 gallon tank, 7-1/2 hp that pumps up to 165 psi, just having 80 gallons of...
    • D
      dfrisk replied to the thread My Free Compressor.
      I worked at an ASME certified company for 4-5 years, built LOTS of pumps and pressure vessels, had our own test chamber in-house, the...
    • D
      dfrisk replied to the thread Repowering a 1282.
      GREG - I used Dave Kirk's first choice of engine machine shops to do all the machine work on my hot-rod K321 and Dave installed my...
    • D
      dfrisk replied to the thread Repowering a 1282.
      A better idea than a Lovejoy coupling is a Magnalloy coupling, we used them on a real high Horsepower but low RPM application about 3-4...
    • D
      dfrisk replied to the thread THE NEW FARMALL H AND M.
      Doug - You are exactly correct. There are a few " invisible" changes, like the top transmission shaft pilot bearing between the input...
    • D
      dfrisk replied to the thread 122 gearing.
      Check the copies of the operator's manuals, they shop travel speeds in each gear, I think the slowest 2nd gear is 3.2 mph, the fastest...
    • D
      dfrisk replied to the thread starter on farmall H.
      CUB 1961 - the best electrical starter generator alternator shop I know is FONDY AUTO ELECTRIC in Fond Du Lac, Wisconsin. 920-922-9130...
    • D
      There were some old lead-acid battery powered fork trucks doing LOTS of work at IH's FARMALL PLANT when I worked there from 1976 to '81...
  • Loading…
  • Loading…
Top