Archive through January 19, 2009

[tbenak]

The angle drive for my QA42A died. The bevel gear and input shaft slid out of mesh and created some problems. Both snap rings were still in place. So I am looking for a good replacement angle drive for this application. Please utilize the email address in my profile. Thanks.

 

[dsauve]

i am looking for a govoner ball spacer for a b43g onan. I got one here with ears broke off. E mail is [email protected] thanks gang.

 

[mstetar]

looking for a cheep 70 or 100 parts tractor western pa preferably

 

[jeeilbes]

I am looking for a complete set up for a rear pto for a 100. Thanks Jesse

 

[agitch]

Wanting the 82 series/wideframe subframe for a 42" blade. I have a narrow frame subframe in great original condition for trade.

 

[rporter]

I am looking for a model 341 42" or 340 40" snow blower to fit my Lt 2138 16 horse, shaft drive Cub. Good condition, within a couple hundred miles of West central Iowa. e-mail: [email protected] Thanks Rich

 

[rdehli]

looking for a narrow frame blade sub frame for my 100

 

[jweaver]

looking for a rototiller for my 122. Jim

 

[dmisiaszek]

Looking for the steering spindle for a 1200 havent really checked what other spindles will fit. I think there are differences in the bends on the steering link on the top of the spindle

 

[ddillon]

Looking for a set of narrow front rims for my 124. Thanks

 

[dmull]

Looking for a differential & ring gear please.

 

[taweivoda]

Rob, I have a complete blade that was on my 102 that I would think would fit your 100. You would get the subframe you need and a little extra. Its a little rusty but in good shape. $40 picked up in SE Minnesota. Let me know if you have any interest.

 

[dmull]

Need the top link attachment point for a 782D cat '0' 3pt please.

Also need pivot point where lift bar attaches to rock shaft for same.

 

[jsdavis]

Hello
I need a brake lever for a 70.Upon disassembly I discovered mine is cracked.

This would be # 8 in the picture.
Thanks,... Jason

 

[rbischof]

Looking for a 54" dirt/snow blade for the older wide frames. Don't need subframe and must be willing to ship if drive is a mega trip. E-mail respondes to [email protected]. Thanks to all.

 

[mtoney]

Looking for a complete Original with a good solid mower deck. Needs to be missing nothing and have its original K161 under the hood. I dont need lights or fenders. Somewhere close to Kokomo IN would be wonderfull. Thanks Mike

 

[ewilliams]

Looking for a brinly sleeve hitch adapter and plow. Email me at [email protected]

 

[dmull]

Looking for #1, #6 & #29 in picture. (off 582)

 

[jsdavis]

Got the brake lever thanks

 

[mbounds]

Model 100 spec sheet.

Myron B
CCSupplyRoom