I am in need of a handle release rod pin/button for the pto lever on my 149. It's p/n IH-376307-R2 and I can't find one. I would be willing to buy the whole handle assembly as well.
who's the guy building the tool boxes for behind the quietline seat? would like to get ahold of him about one for my 1650. I know he had them advertised on here some time back, but can't find anymore.
Looking for the rear driveshaft coupling for my 1872.Parts lookup says #903-1066.It's the one that slides right on the hydro input shaft.Tractor serial # 791396.
Thanks for any help, Bob
I found a crack in the dash of my 149 so I'm looking a replacement in decent shape. All I need is the plastic dash. If you have one please contact me by email at [email protected] and let me know a total with shipping to 27516 in North Carolina.
looking for a seat for a 122 in usable shape, the fiberglass one, its to replace the one on the 122 on my cub site www.exedown.us let me know what you have its a christmas gift
I'm looking for a "Grote" tail light used on the older IH built Cub Cadet narrow frame models such as "Original", 70, 100 and so on. Willing to buy it or trade new main CC wiring harness.
330 592-5640 or email me
Thanks,
Mike
Jim D: Are you looking for the hood latch shown on page 8, or the hood support shown on page 47, Section E (for the 682), TC193?? I find no hood brace shown.
Jim D: At the moment I do not know if I have such but I'll check it out tomorrow. I didn't get much 82 series specific stuff from that old dealership I partnered into.