balbrecht
Well-known member
Got bit by the archive bug.
Tiller listed below is spoken for. Today's garage clean out items:
CCO grille, brace and metal emblem. No breaks in anything but a few of the wires around the edge could be straightened and it needs sandblasting and painting. $65 shipped USPS to the lower 48
Headlight set for a 71,1X2, 123. Headlight panel has some surface rust on the front. Two of the mounting posts are great, two have a rub spot where the corner clamps rubbed the post. I don't think that will impact installing it, but I'll include two extra corner clamps to use as a an extra spacer if the nut needs to be higher out on the post. Bulbs work, but have yellow over spray on them. Tail light has a new bulb and I'll include a new lens because the original has some scratches. I added some solder where the pigtail goes into the light because a couple of the wires had started to fray. I'll include a new pigtail wire that you can use instead if you wish (sorry about the yellow, I couldn't find a red one). Tail light has one small dimple in it on the bottom (see picture) and the bracket could use to be straightened (see picture). Light switch tested good for continuity but is missing the correct spacer washer and has some yellow paint on it. I've added two machine bushings which will work to install it, but are not correct appearance wise. $130 for the set shipped USPS to the lower 48. Higher resolution images available, email in profile. Thanks -Brian
Tiller listed below is spoken for. Today's garage clean out items:
CCO grille, brace and metal emblem. No breaks in anything but a few of the wires around the edge could be straightened and it needs sandblasting and painting. $65 shipped USPS to the lower 48
Headlight set for a 71,1X2, 123. Headlight panel has some surface rust on the front. Two of the mounting posts are great, two have a rub spot where the corner clamps rubbed the post. I don't think that will impact installing it, but I'll include two extra corner clamps to use as a an extra spacer if the nut needs to be higher out on the post. Bulbs work, but have yellow over spray on them. Tail light has a new bulb and I'll include a new lens because the original has some scratches. I added some solder where the pigtail goes into the light because a couple of the wires had started to fray. I'll include a new pigtail wire that you can use instead if you wish (sorry about the yellow, I couldn't find a red one). Tail light has one small dimple in it on the bottom (see picture) and the bracket could use to be straightened (see picture). Light switch tested good for continuity but is missing the correct spacer washer and has some yellow paint on it. I've added two machine bushings which will work to install it, but are not correct appearance wise. $130 for the set shipped USPS to the lower 48. Higher resolution images available, email in profile. Thanks -Brian