holiday greetings to all:i do hope that my question is posted in the correct forum....my problem is the same,i have a model 71 and 72.they both have the k161 7hp kohler motor.i thought i would give the 72 a carburator kit which included a new needle seat,needle, float,and float pin.i believe that the float level is not correctly set based on doing everything else correctly.even though i have the BLUE RIBBON SERVICE manual pt.no.gss-1398,i still have trouble to understand this direction.not quite sure where to take measurments from and how to adjust.any information would be helpful.thank you.