Archive through June 27, 2016

[jwiggins]

International Harvester IH Cub Cadet rear end housing or transmission "CASE" part# IH-394081-R91

Parts Look up shows same part# for both the 149 & 1250

149 Rear Looks like This:

1250 Rear Looks like This:

Upper Left corner of housing or casting about 10 o-clock position has an "Extrusion" on the 1250 Rear that is not Present on the 149 Rear?

I wonder if the Later Design Model 1250 w/ the extrusion would be considered any "Stronger" possibly, or if there was Any Specific Reason or Purpose for the Design Change?

 

[jwiggins]

149 Rear:

1250 Rear:

 

[fcurrier]

Dawn and Don, Christmas, 2015:

Don passed about 10pm last night. We'll miss him.

 

[sblunier]

Sorry to hear about Don T.

Jason,

If you have charge pressure at 100/200# and lift pressure at 400# your hydro is getting oil.

Your issue is very likely in the linkage......go over it with a fine tooth comb.....make sure it is all functioning and has full travel.

Double check trunion springs and neutral adjustment (slotted holes in bracket on left side of hydro)

 

[jwiggins]

Frank C.

Condolences,

Steve B.

Will Do, Thanks!

 

[nbextermueller]

Woah... No more Don T? It is a very sad day for IHcubcadet... RIP Don, hope your cubbing up there with with the best of them.

Prayers for the family.

 

[mgwin]

Sure will miss Don's posts on this forum.

 

[hydroharry]

It is truly a sad day. Don and his posts, are and will be missed. I wish all the best to his family.

 

[bwittman]

I am saddened to read of the loss of Donald Tanner. I very much enjoyed his posts. He was an integrigal part of this community.

From Frank's photo, it appears as if Don chose his dogs quite well, too. I know they will miss him, and I offer my prayers to his wife and family.

 

[kshultz]

Dang.... that's terrible news.

Never met Don T., but I did like reading his posts. It's kinda like losing a "cyber brother". RIP