Ok, just got done rebuilding my 8HP Kohler K181.
I'm trying to adjust the governor. I looked in the FAQ and didn't see it.
Right now I'm just putting around in 1st gear low RPM with SAE 30 oil. How long should I run it before I change that oil?
Also, I don't have the Points cover on right now because I am going to change them. I noticed a little crankcase vapor comming from that area. It's cold out so i'm sure just a little will show up.
I installed my breather with the reed facing me as it went on, (this is the way they show it in the manual) where does the crankcase vent to? It seemed like there was no holes or anything in that valve cover to let any pressure out.