Don, you can use a banjo bolt as seen on evilpay, try a metric capscrew but I believe you need a 10mm one. They aren't expensive. The drain fitting may have been on the one I sent, if not these are simple to make or buy (same place) The oil pressure line can also be purchased there, I went with a stainless tell braided line these may. not come with fittings. You will tap into the oil gallery where the sending unit is, run a tap for 1.8" NPT and clean well. Then install a close nipple and 1/8" tee. Screw the sender back in the straight out side and the adapter for oil hose on top of tee. These are often a tapered fitting to match the hose, usually size 6AN on one side and 1/8" pipe on the other. As usual this stuff is all available on the Evil site under turbo or I use IHI as a brand, just type IHI in and search away. See the other posts fro planning your oil return/drain back to sump. The recommended size for the return is approx. 3x the diameter of the oil feed line ID. This will account for oil expansion from the heat as well as insure no restriction of flow, very important. well, that's the start, ask away for more as needed.