I collect elec-traks and I saw one of these mowing rigs. It looked like it would work well for me so this is what i came up with. The Haban sickle bar is a 402 D off a cub cadet
I have a miss matched set of shear fingers and cutter bar and can not get them aligned properly. The older mowers had single fingers and more offset than the newer replacement double fingers(part#6732). So I need a set of older single fingers. , Here is what I have (part#6732)
and here is what I need (I couldn't get the photo to up load so here is a link to a photo)
http://picasaweb.google.com/111041709953859323852/ElecTrakProjects#5523105991584094786
I am hoping one of you cub folks might some Haban parts hanging around. I will need 16 #3599A and 1#3599B early shear fingers or a newer style two piece bar. It was a complete mower and I do have the parts available that I didn.t use,just pay shipping from Maine.
I have a miss matched set of shear fingers and cutter bar and can not get them aligned properly. The older mowers had single fingers and more offset than the newer replacement double fingers(part#6732). So I need a set of older single fingers. , Here is what I have (part#6732)
and here is what I need (I couldn't get the photo to up load so here is a link to a photo)
http://picasaweb.google.com/111041709953859323852/ElecTrakProjects#5523105991584094786
I am hoping one of you cub folks might some Haban parts hanging around. I will need 16 #3599A and 1#3599B early shear fingers or a newer style two piece bar. It was a complete mower and I do have the parts available that I didn.t use,just pay shipping from Maine.