The mower shows no model or SN. Believe it to be oem to the Cub when built in '66. The mower blades, two at 10 3/4" and one at 22 1/16" had never been removed. Needed my Fein Multimaster with carbide cutters to cut thru the nuts holding blades in place. My Dad always said... "if you have the right tool you can do anything."
Wanted to change out the belt, thought the way to do it was to put a wrench on the hex bolt (see pix #1and see pencil in 4th pix), so I did and it collapsed in pieces leaving a typical washer and an odd-looking washer with a teat on it. Now, it looks like loosening the blue-marked hex bolt will loosen everything. Right? And what the purpose of the collapsed piece? I'm lost.
In the 4th pix the grease fitting is bent. This ought be replaceable, yes?
As usual, help please.
Jack C
Wanted to change out the belt, thought the way to do it was to put a wrench on the hex bolt (see pix #1and see pencil in 4th pix), so I did and it collapsed in pieces leaving a typical washer and an odd-looking washer with a teat on it. Now, it looks like loosening the blue-marked hex bolt will loosen everything. Right? And what the purpose of the collapsed piece? I'm lost.
In the 4th pix the grease fitting is bent. This ought be replaceable, yes?
As usual, help please.
Jack C