Help Support IH Cub Cadet Forum:
D
dsarow
- Messages
- 69
- Reaction score
- 28
Latest activity Postings About
-
-
DYou're much safer with a thread chaser. They'll realign distorted threads, such as can happen at the top of a hole, without cutting new...
-
DIf you change the sparkplug when the head is cold you will likely never have a problem.
-
DMy 1st thoughts as well.
-
DAlways check wit hour sponsers! Cub Cadet Parts International Harvester IH Cub Cadet CubCadet MTD CCC Parts colorful boxes up near...
-
Ddsarow replied to the thread SPRING IS HERE!!.So "Happy Wife is Happy Life",just wondering
-
D100 Owner's Manual 100 Service Manual Kohler K-series Service Manual Head Gasket Replacement If you replace the points, you may find...
-
Ddsarow reacted to dschwandt's post in the thread Engine "frozen" after belts replacement. with
Like.
I agree... Yes, by all means do that first -
DLike what you're doing to bring the 782D back to life. I was wondering what is supposed to keep that check valve ball from falling out...
-
DColton, a V belt transfers the power from the engine to the mower by the sides on the V belt..There is no power transfer on the ends, so...
-
DI'm also curious if you even have the right belt! Width of the belt? Length? What is the PTO off of?
-
Ddsarow replied to the thread Clutch issue.Noises,we've all been there!Good luck,sounds like you hav a plan
-
DSteve I would lose the10m min bet cause it would take me 20 to figure out where I left the puller! :ROFLMAO:
-
DSUCCESS Sorry I did not wan"t try poundin the spindle with a air hammer or sledge. As Frank said " I did it my way" The best tip I got...
-
DYou can lead a horse to water, but you can't make him drink! :errrr:
-
DNever in my life have seen so much work go into one of the simplest task known to remove ANY steering wheel on a Cub in less that 10...
-
-
Loading…
-
Loading…