• FIRST AND LAST NAMES ARE REQUIRED WHEN REGISTERING
shop deals on amazon
Shop deals on ebay
cub cadet used parts
kirk engines
IH Cub Cadet Tractor Forum

Help Support IH Cub Cadet Tractor Forum:

dkirk

dkirk

IHCC Supporter
Well-known member From Fond du Lac, WI
Joined
Last seen
Messages
492
Reaction score
238

Latest activity Postings About

    • dkirk
      dkirk reacted to Todd's post in the thread K301 turbo? with Like Like.
      I figure that conventional wisdom on turbos implies already relatively clean gas flow - something that a flat-head is decidedly NOT...
    • dkirk
      dkirk reacted to snicklas's post in the thread K301 turbo? with Like Like.
      I know that I'm not the OP.... but my guess would be: "Because I can" Someone wants to try something different.... Some people like...
    • dkirk
      dkirk replied to the thread K301 turbo?.
      A turbocharger needs to be matched to the engine displacement and intended operating rpm. I don't know of any turbo small enough to...
    • dkirk
      dkirk reacted to mgwin's post in the thread muffler tape on round muffler with Like Like.
      What kind of muffler are you referring to? A 100 muffler should look like this. For a totally correct muffler, it would have a...
    • dkirk
      dkirk reacted to mgwin's post in the thread No compression on 108 with Like Like.
      Even though all the suggestions are very good, it would be impractical to perform most of these in someone's yard that you do not know...
    • dkirk
      dkirk reacted to Curt Doles's post in the thread Deals with Like Like.
      Thanks, I learned something there!
    • dkirk
      dkirk replied to the thread Deals.
      Side panels, larger muffler, rubber mounted engine, air filter inlet directed into cooling air shroud, enclosure surrounding muffler.
    • dkirk
      dkirk reacted to jdrong's post in the thread Smoking Coil with Like Like.
      From what I remember, early cars, etc. only needed an external resistor when using a 6-volt coil in a 12 volt system. The 6 volt coil...
    • dkirk
      dkirk reacted to ajtimm's post in the thread Smoking Coil with Like Like.
      New Kirk Transducer II, Coil and spark plug Wire. Started first turn. My 11-year-old is driving circles in the driveway now.
    • dkirk
      dkirk replied to the thread Kohler 12hp-no oil filter?.
      You can visit the Kohler engine website and view the oil viscosity recommendations on synthetics. What you state was true during the...
    • dkirk
      dkirk reacted to rfunk's post in the thread Kohler 12hp-no oil filter? with Like Like.
      Anecdotal: my magnetic plug sure pulls a lot of metal out of my oil. (Somewhat delayed second oil change after rebuild)
    • dkirk
      dkirk replied to the thread Kohler 12hp-no oil filter?.
      A magnetic drain plug is a suggested addition to the K-series Kohler engines. Most of the harmful metallic deposits in the engine oil...
    • dkirk
      dkirk replied to the thread CC 1250 Engine Overhaul.
      If the rod bearing has excessive clearance, you should be able to feel this in the crankshaft. Rotate engine backwards by hand until...
    • dkirk
      dkirk reacted to PACub100's post in the thread CC 1250 Engine Overhaul with Like Like.
      No doubt. My 1450 did that before I got in there and bolted down the muffler housing. Get a muffler crutch off of Kirk above and put...
    • dkirk
      dkirk reacted to dschwandt's post in the thread Smoking Coil with Like Like.
      Good grounds, clean tight connections and terminal connectors are very important areas that merit attention on these or any other...
    Show older items
  • Loading…
  • Loading…
Top