• This community needs YOUR help today. With the ever increasing fees of everything (server, software, domain, e-mail) , we need help. We need more Supporting Members, today. Please invest back into this community to help spread our love and knowledge of IH Cub Cadets. You get a lot of great new account perks including access to private forums. If you sign up for annual, I will ship a few IH Cub Cadet Forum decals too in addition to all the account perks you get. You can see what it looks like below.

    Sign up here: https://www.ihcubcadet.com/account/upgrades

Recent content by bfleisch

Advertise with us
cub cadet used parts
cadet connection
shop deals on amazon
IH Cub Cadet Tractor Forum

Help Support IH Cub Cadet Tractor Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. bfleisch

    Kohler 7 hp 161 rebuild kit

    I used Kohler Pistons several times. He usually has some OEM and aftermarket parts available, But on some of these engines not all options are available any longer. And as mentioned earlier unless you have it measured or measure it yourself you don't know what size piston/rings you need.
  2. bfleisch

    She is done

    Excellent, love the sound of the old small Kohler
  3. bfleisch

    Cub 100 Engine

    Here are a couple picture of a restoration I did a couple of years ago. Your engine looks similar with the exception of the throttle to govern shaft control.
  4. bfleisch

    Rear tires 23/10:50-12

    I have used Miller for years and always get good quality. I am restoring an Allis Chalmers B12 at the moment ( I now not a cub) and I got the fronts V61 though Miller and then when I looked at the Ags I found the same exact ones on Amazon for less money with free shipping. Never happened before...
  5. bfleisch

    Work begins on 104

    I drilled and tapped a couple of holes in the pulley and used a regular wheel puller, not 3 jaw to get mine off along with heat and PB Blaster. You can see the two holes in the pulley in the picture. It worked well and had no affect in damaging the pulley.
  6. bfleisch

    No spark 1450 w/ K321 engine

    You have the points gapped correctly? Remove the points wire from the coil and use a meter, one lead on ground and the other the points wire and turn over by had and make sure you see it go from a short ( 0 ohms) to open ( infinity or OL depending on meter). That does not check for the correct...
  7. bfleisch

    Favorite model?

    I like the simple ones also. This was my 100 that I had finished this was my Original in progress. My avatar shows the Original completed.
  8. bfleisch

    Four digit original

    When I opened up the rear end of my original it was painted red also. As mentioned above I suspect the primer.
  9. bfleisch

    Unknown Cub Cadet With Problems

    No matter what you have a unique one of a kind tractor. Nice !
  10. bfleisch

    K161 Governor Assembly

    This was mine. I picked up another one on eBay.
  11. bfleisch

    Dash tin decal

    I used them for my Original and had no problem with the set I received
  12. bfleisch

    original cub engine problem

    I would probably pull the head and turn it over by hand to make sure everything is behaving properly.
  13. bfleisch

    early fathers day present, 4 digit original

    Great story !
  14. bfleisch

    K321 Laboring hard after warming up

    Is the governor responding when you idle up?
  15. bfleisch

    100 Refurbish

    Excellent !
See more
Back
Top