• This community needs YOUR help today. With the ever increasing fees of everything (server, software, domain, e-mail) , we need help. We need more Supporting Members, today. Please invest back into this community to help spread our love and knowledge of IH Cub Cadets. You get a lot of great new account perks including access to private forums. If you sign up for annual, I will ship a few IH Cub Cadet Forum decals too in addition to all the account perks you get. You can see what it looks like below.

    Sign up here: https://www.ihcubcadet.com/account/upgrades

Search results

cub cadet used parts
Shop deals on ebay
Advertise with us
cc specialties
IH Cub Cadet Tractor Forum

Help Support IH Cub Cadet Tractor Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. J

    Deck and Mule Drive Parts

    Martin, I totally agree with Tom! Cubs are good for a lot of things other than cutting the grass. I too mess around with a lot of "old stuff" and I'd rather use my cub to plow my small garden, spread dirt and harrow with. I have about 5 decks ranging from 38" to 50" and I still get a much...
  2. J

    Rear wheels

    Be careful and check offset also. I purchased a pair of "CC" rear wheels from a guy that had a lot of parts. Looked just like the 6 X 12 Cub wheels. Turned out they were right width and size, but offset was about an inch deeper....like a Craftsman Suburban! It makes the wheel and tire stick...
  3. J

    Towing ability 127

    Just remember if you have a gear drive cub, if the weights too heavy, you run the risk of breaking something in the drive line....just a thought. I just had to replace the clutch and drive plate in my 1200 because I didn't let up plowing. Not a fun task! Ed
  4. J

    IH Cub Cadet Pulling and Hot Rodding

    Don, The bearings are from the balance gears, not the crank. Why would you leave them out? I've always heeded your advice and never gone wrong, but don't they help in the "shake"? Ed
  5. J

    IH Cub Cadet Pulling and Hot Rodding

    Here's another question for the forum! I did the classic St---d thing in an effort to "dry" my crankshaft counterweights. I blew it off with my air hose and I now have about a hundred needle bearings all over my garage floor. Is there a bearing replacement or do I have to replace the entire...
  6. J

    IH Cub Cadet Pulling and Hot Rodding

    Kenny, Thanks! If all else failed that was the one I was going to use. Thanks again. Ed
  7. J

    IH Cub Cadet Pulling and Hot Rodding

    Hey Ya'll, Need some Expert advice. I'm trying to put my 12hp out of my 127 back together and wasn't paying attention to the timing marks on the crank when I took it apart. The book doesn't do it justice either. Which one of the marks do you set the cam and crank to? I have a mark on the...
Back
Top