• This community needs YOUR help today. With the ever increasing fees of everything (server, software, domain, e-mail) , we need help. We need more Supporting Members, today. Please invest back into this community to help spread our love and knowledge of IH Cub Cadets. You get a lot of great new account perks including access to private forums. If you sign up for annual, I will ship a few IH Cub Cadet Forum decals too in addition to all the account perks you get. You can see what it looks like below.

    Sign up here: https://www.ihcubcadet.com/account/upgrades

Search results

cub cadet used parts
kirk engines
shop deals on amazon
cadet connection
IH Cub Cadet Tractor Forum

Help Support IH Cub Cadet Tractor Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. D

    Any word on Blunier plow day Roanoke IL for 2015?

    can't find anything.
  2. D

    Archive through September 05, 2012

    The pto on my 682 is starting to make noise when not engaged. The parts break down makes it look like I could have to replace complete pto, as it shows no bearing. Is there a bearing that can be replaced and if so, were can I buy one? thanks
  3. D

    Archive through August 20, 2012

    can anyone tell me what parts I need to install an oil filter on my kt17 series II and where I can get them? thanks
  4. D

    Archive through June 27, 2012

    Need a new carb for my 14hp kohler. Are the new walbro replacement carbs without the high speed adjustment working out OK? Been looking for older carb to rebuild, but they either want a fortune or the throttle shaft has a lot of movement and then your spending more money to fix that, with no...
  5. D

    Archive through May 17, 2012

    Will the series II engine from post IH 782 fit directly into IH 782 with series I engine, are any mechanical or electrical changes required? thanks
  6. D

    Archive through April 01, 2012

    would the kt17 series II engine from a 1720 be a direct swap into a 782?
  7. D

    Archive through December 20, 2011

    782 sprung a leak on trans, things to look for? Started up my 782 let it warm up a while and moved it from one building to another and shut it off. Come back couple hours later and find puddle of oil under trans area. Looked at front of trans area and it's wet all over. Looked at where tractor...
  8. D

    Archive through November 26, 2011

    Very nice condition Cub Cadet model 127 garden tractor, hydrostic drive, electric lift, newer tires, wiring, owners manuals, battery, new front wheel bearings, newer paint. Comes with 42" mower deck, 42" snow blade, chains. Also includes upper lift arm for rear three point lift, but does need...
  9. D

    Archive through September 21, 2011

    Are the rear wheels a different width for 8.5" and 10.5" wide tires. Need to find a rim and want to make sure I find the right one. thanks
  10. D

    Would you buy 154 or 184

    have chance to buy a 154 with creeper or a 184. both in about same condition and price range. can't make up my mind, so looking for opinions. thanks
  11. D

    Archive through August 05, 2011

    Thinking about getting a 60" swisher offset mower to tow behind 782 to decrease mowing times. Any thoughts or opinions?
  12. D

    Archive through June 02, 2011

    Will this Kohler magnum 18 fit in my 782 without a lot of hassle? thanks
  13. D

    Archive through May 29, 2011

    my 127 start/generator is not charging. Does anyone know of a place that can fix in the Rockford IL general area? It was supposedly rebuilt last fall, but not charging and when measuring across A and F terminal reads a direct short.
  14. D

    Archive through May 11, 2011

    just found 12" brinly plow close by, would my 127 be able to handle it?
  15. D

    Archive through May 11, 2011

    Is a roll pin used to connect drive shaft to flange on engine on my 127? PO has a couple of tack welds along with a nut and bolt installed and that does seem right from a point of engine balance.
  16. D

    Archive through May 07, 2011

    782 backfires through exhaust for a little while, then runs fine the rest of time. Does this sound like sticky exhaust valve???
  17. D

    Archive through May 04, 2011

    Does anyone make a rotary broom that will fit on a wide or narrow frame Cub??? Need to find and easy way to get gravel out of lawn.
  18. D

    Archive through April 24, 2011

    Have a 127 with electric lift. Is there a way to lower mower deck to specific position after raising it or is it just a guess? My 782 has mechanical stop, but I can't find anything on 127.
  19. D

    Archive through April 13, 2011

    Looking for any information on this plow. thanks!!
  20. D

    Archive through February 21, 2011

    I'm now a collector, just got number 2!!!
Back
Top