Recent content by ncovey

There is no voltage at I/J. There is no voltage at A when the battery is disconnected. The circular connector shown on the diagram is a 10 pin female connector device. The connections shown on the diagram are wires internal to the engine. There is nothing external connected to the engine...

I got it oiled up and a little gas in the fuel pump, cranked it for about 5 seconds, it popped and sputtered about three times and wham - 3600 RPMs. However, there is not 24v on I and J. there is nothing. I think there is another wire, that is not in the diagram, that goes to a lug on the...

EURIKA 7/8s

Yup, I thought I would try that but I haven't attempted starting it yet. At the present time I am trying to remove the spark plugs so i can spin it without compression and throw the oil around a little. I can't get a socket on the plugs numbered MS 51009-3. Whud-a-thunk-it. I don't know if...

Many thanks for the responses and interest in my little 4a084 project. dross: yup, A thru J are connectors and I agree, I can't see how the batteries are charged - not enough info. I am about to the point of just using a trickle charger when the thing is parked in the weeds. My concern with...

Actually i am trying to figure out the wiring on a 4a084 Teledyne engine so I can put is on a DOSKO wood chipper. I sent aschmidt (much thanks) an email and, along with other folks, have figured out the ignition on/off, the starter button, and the battery hookup. I am still in the dark about...

I am new to this great site. I am trying to figure out how to wire a 4a084 engine using the manufacturers installed wiring loom. Need to know how to switch the ignition, install a starter button and keep the battery charged. Norm Covey

Much appreciate your help. I'm a newby on this website and apparently didn't spend enough time looking around before I jumped in. Thanks very much. ncovey

aschmidt and sarcher have great, interesting projects underway. Look for recent posts: https://www.ihcubcadet.com/forum/messages/19397/228217.html?1312138445 I am intending to use a belt drive setup which will reduce the speed of the chipper flywheel from 3600 engine rpm to about 2300 on the...

I’ve been poking around on the CubCadet web site and stumbled across a couple examples of CubCadets with 4a084 (or smaller) engines. I do know that these engines are USGov’t surplus that come with a manual that assumes the reader knows what he is doing. I don’t qualify. I don't know what the...