Recent content by mlies

Question; I have a 149 cub and I am looking to convert it to hydraulic steering cheap. Found steering columns on ebay like JD. Wonder if it could run off the hyd lift lines and if it is in the archives and which archive. I am planning on using the cylider off the hyd lift for the steering. Do I...

The cub cadet 108 is sold. Frank thank you for posting my pics.

I have a cub cadet 108 with a rebuilt engine new tires up front with snow plow, and a partially built pf engineering endloader, no hydraulics and no steel for the bucket. also with this is a parts 102 rear end. Engine has new rod piston valve guides and valves bored .020 over. selling for 550.00...

Thanks Don T. I just hope I didnt do any damage to it since it is a brand new engine. I can see through my baffle after I got rid of the packing. Thanks for the info.

I have a 108 cub cadet with a 10 hp and a plow, I also put a stack on it with packing in the baffle which makes it very quiet. The problem I had was it seemed very doggy when in 3rd gear pushing alot of snow it would die out and take quite awhile to recover is this because I have restricted the...

Trailer is sold.

Just wanted to let you all know my cub charges awesome thanks to all. Mike

Thanks for all the input guys. I appreciat it greatly. Thanks again.

Ok I will use the enter key thanks for that info I didnt like looking at it myself and thanks for explaning the whole spacer thing that makes sense now. For the regulator if there is no ground on it at all how does it connect ground for the field to work?

Oh Ok I hit the space key 5 times it still didint work Ill try that next time. I have another question I bought a regulator off ebay for a 125 but that is not what it came off of the post on mine go bat gen field and ground on the other side this one goes L batt F and gen is on the other side...

I tried to put a space between the picture and the wording but it didnt work tried 3 times and now I cant get at it it wont let me. Is there a different way because the note pad with pencil isnt working. thanks Mike

I have a question on the 108 driveline there is a spacer by the pressure plate on the clutch and then a spring mine has a narrow washer for part number 20 my clutch works ok it seems to be hard to disengage well it has a little drag sometimes but it the correct spacer is in there it would put...

Ok I have seen cuts in the front axle and hear that they break etc. I have bad cuts in mine and wonder if the snow plow is going to end my fun this winter. Can it be welded or reinforced in any way? Thanks for any replies.

I have this trailer if anyone is interested letting it go for 150.00.

Here are the pics of the 127 project has incorrect engine it is a 10 hp missing generator, coil, carb. everything else should be there, also has 42 inch and 38 inch decks. Trade for two cast 50lbs each wheel weights for 12 in wheel or 150.00