-
This community needs YOUR help today. With the ever increasing fees of everything (server, software, domain, e-mail) , we need help. We need more Supporting Members, today. Please invest back into this community to help spread our love and knowledge of IH Cub Cadets. You get a lot of great new account perks including access to private forums. If you sign up for annual, I will ship a few IH Cub Cadet Forum decals too in addition to all the account perks you get. You can see what it looks like below.
Sign up here: https://www.ihcubcadet.com/account/upgrades
Help Support IH Cub Cadet Tractor Forum:
gloughery
- Messages
- 138
- Reaction score
- 19
Latest activity Postings About
-
-
gloughery replied to the thread 100 or 122.Nice! Thanks for photos! -
Hello, I am doing the super steer upgrade with an 1863 axle (part 719-3101) on both a narrow 122 and a wide frame 169. I bought two and...
-
-
gloughery replied to the thread 100 or 122.+1 vote for the 122. I have a 70, 100, 122 (avatar), and a 169. My all-time favorite is the 122 with creeper. I'll assume this is your...
-
gloughery replied to the thread Hello from the Florida Panhandle (Tallahassee).Welcome Floyd, my first was a 70 that I used to cut grass. I had all the parts and came here to this site for advice with belts and mule...
-
I purchased what was thought to be a good complete creeper. Before I installed it I realized that the planetary gears were missing. I...
-
gloughery replied to the thread Creeper Gear for a Cub 100 Help.Hey Gerry. Please post a photo of the gear. I'm doing the same project and always like to see if my old parts are worn to the point of...
-
gloughery replied to the thread Drive shaft constantly spins CC100.Just a follow up. Oil on the pilot bushing and loosening the engine around did the job!
-
Probably almost any early tractor would be fine. Since we are not pulling tree stumps up out of the ground, or blowing snow 300 feet...
-
gloughery replied to the thread Drive shaft constantly spins CC100.The oil is coming from over zealous attempts to keep everything lubricated, long story.
-
gloughery replied to the thread Drive shaft constantly spins CC100.Found a bushing (IH-376265-R1) but don't understand where it goes. Here in the driving plate (#8)?
-
-
gloughery replied to the thread Drive shaft constantly spins CC100.Thanks to all, yes a lot of oil that I need to clean out. The pilot bushing? I'll have to look at where that is, I don't remember. I...
-
Need advice why the drive shaft constantly spins. Photo shows pressure plate pulled away for inspection and engine not running. Tried...
-
-
gloughery replied to the thread Fuel sediment bowl elimination.I vote for sediment bowl as well. The gasket is easy to cut but my troubles always come from getting the packing material to set...
-
-
Loading…
-
Loading…
