Looking for a right side rotor housing for cub 100 42inch deck. My pulley wore through mine. I could probably take new bearings, pulley... maybe it's easier to send as an assembly
A little more information. I suspect the reason the negative battery terminal is grounded to the frame is because the previous owner switched to heavier battery cables and a battery with car type terminals (posts) not the "L" terminals
So follow-up. I went ahead and ordered the voltage regulator and brushes for the starter/generator. The old VR is different than the new one I ordered. The old one has the F, GEN and BAT posts and a post for a ground. The new one has F, BAT, L and GEN and is grounded to the frame by the...
I was getting the same voltage reading on the coil and VR as the battery so I figure those connections are good. Of course the number was down to 12.41V after trying to start numerous time. The voltage at the S/G was 11.96V when pushing the starter button.
When ordering the VR I noticed it's...
Finally got my 100 running again after months. replaced a non-original ignition switch with a original type and it wouldn't run. It would only run if I held in the start button. Turns out the wire to the battery post on the voltage regulator was connected to the wrong side of the start button so...
Finally got my 100 running again after months. replaced a non-original ignition switch with a original type and it wouldn't run. It would only run if I held in the start button. Turns out the wire to the battery post on the voltage regulator was connected to the wrong side of the start button...
I got home today and there was a box from Vogt Performance Engineering in the mail. I opened it to find all the parts I need to fix the debilitated spindle on my 100's mower deck. I was so pleased to see these used parts in such good condition. Everything I needed and little more was...
This post will attest to my novice abilities but I'm posting anyway - Recently I had trouble getting drain plug out of creeper to change oil ('64 CC 100). Nothing worked so someone suggested torching/heating to get it out. My neighbor obliged and helped by trying that and also welding a hex...
I'm looking for parts to fix a debilitated outer blade assembly on my '64 Cub 100 38" mower deck (posted in wanted section). I'm just curious, I looked at the parts diagram online and there appear to be fewer parts in the diagram than parts I pulled out of mine. For instance, mine has two...
Wanted - outer blade spindle assembly for '64 Cub Cadet 100 38" mower deck.} Need just about everything (bearings, washers, spacers...) except the blade and pulley wheel. Also need the seal (rubber in metal ring) that presses into the deck. Thanks. If its helpful, I can try and round up the...
My father-in-law gave me a '64 Cub Cadet 100 a couple/few years ago and I am finally getting around to changing the creeper drive oil. I tried to loosen the drain plug (very hard to get to) but ended up just rounding out the square end as it wouldn't budge. Any suggestions as to what size and...