• This community needs YOUR help today. With the ever increasing fees of everything (server, software, domain, e-mail) , we need help. We need more Supporting Members, today. Please invest back into this community to help spread our love and knowledge of IH Cub Cadets. You get a lot of great new account perks including access to private forums. If you sign up for annual, I will ship a few IH Cub Cadet Forum decals too in addition to all the account perks you get. You can see what it looks like below.

    Sign up here: https://www.ihcubcadet.com/account/upgrades

Recent content by jdonovan

Advertise with us
cub cadet used parts
cadet connection
xtreme motor works
IH Cub Cadet Tractor Forum

Help Support IH Cub Cadet Tractor Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. J

    Wanted To Buy

    I am looking for someone who lives near Moorhead, MN that can pick up a non tractor part(wood planer) for me. Please pm if you can help. Willing to compensate. Thanks..Joe
  2. J

    Archive through May 24, 2016

    Looking for advice whether or not anything should be used on the gaskets for the reduction housing or differential cover. Gasket shellac or gasket adhesive etc.Thanks in advance..Joe
  3. J

    Archive through May 16, 2016

    Thanks Charlie >..Joe
  4. J

    Archive through May 16, 2016

    Looking for suggestions on what to use to clean the rear end and transmission of my Original. Hoping to avoid stripping the protective coating(?) that's inside the housing. Thanks..Joe
  5. J

    Wanted To Buy

    Looking for a creeper for my Original. Thanks in advance..Joe
  6. J

    Archive through May 02, 2016

    Since my throttle lever was in good shape, I found a new metal cable at NAPA. Cut to match the original one.
  7. J

    Archive through May 01, 2016

    The throttle cable on my Original needs to be replaced. I was able to remove the wire from the metal casing. Anyone know of a universal cable where either the wire will fit the original metal casing or a new one that will screw into the throttle lever. thanks in advance..Joe
  8. J

    Archive through November 20, 2015

    knobs are spoken for. Thanks..
  9. J

    Archive through November 20, 2015

    Angle knob for back blade/rake. The new knobs appear to be pretty close if not exact as my NOS one (green x is the nos one). $10 each, shipping included. I have 5 available..
  10. J

    Archive through September 03, 2015

    looking for an early pedestal(no slot on side) for my original
  11. J

    Archive through September 25, 2015

    Rebuilding/ cleaning the steering column from my original. There are 10 ball bearings on either end of the shaft and no retainers. The replacement parts have only 8 ball bearings, which include retainers. Are the new parts compatible or should I stick with the original parts. Thanks in advance..Joe
  12. J

    Archive through September 03, 2015

    looking for a cub cadet weight/utility box for my original. Thanks in advance..Joe
  13. J

    Archive through September 03, 2015

    I need 3/4" but if they are longer I can cut them down.
  14. J

    Archive through June 20, 2015

    Looking for 5/16" carriage bolt with "IH" on the head. Need 1 but will buy 7 if available. Thanks in advance..Joe
  15. J

    Archive through August 30, 2015

    Kraig, I don't have the manual, just the paper I posted. Guessing this was the first way the blade mounted before the revision? Also notice that there aren't any holes for the skid shoes. Joe
See more
Back
Top