gregplaine
I have had the same tiller on a orginai a 100 and a 122 cadet. I now have the same tiller on a 482, useing the same hitch, simple by drilling the shaht size bigger and adding spacers on each side. The lift arm is off a 104 rod and helper spring the same. made plates on rear to put...
on the voltage regulators the three and four post will interchange, the fourth post is marked l for load. It just send curent to the switch or where ever you want power without going to the bat. or someother power supply. Just hook (g)to generaterand (b) to batt (f)to the field post
I was reading the imfo on the throttle shafts. I use a fivesixtenth steel gas line. After removeing the shaft,I use a pin to line the carb. hole up on the drill press. Than remove pin ,put the bit in and drill the top hole out. I than install the steel bushing works great.
You showed me your 1000, you picked up. A man came up to me a couple of weeks ago and ask if I would be interested in a cadet. When I, asked how much he replied, when I clean my shed out I`ll load it and deliver it to your house. When he gets the 782 here I`ll send a picture. Did I mention it is...
gharbaugh
Hi guys,here in centeral Ill. we haven't even had enough snow to try the snowblade out. I seen one of my old bosses the other day and he gave me a 1650cadet, has a lift hitch onit to. Didn't notice if it had the helper spring or not,have a couple of them.
George Harbaugh, Feb 19
I have been reading your notes, they are interesing. I just built a three foot wheel disc, put hydralic,duals on a 582. Along with twin pipes, sounds great. has a 16twin cyl in it.Have a three pt. to put on it too.