I mounted my snow thrower on my 125 and tried to tighten the belt using the piece of hardware on the side of the thrower but it seems to loosen the belt rather than tightening it. I must be misisng something.
Starter not working on 125. The solenoid clicks but the starter does not turn the engine over. Where shoudl I start: replace the brushes or is it better to just get a new starter/generator.}
Steve Blunier - The pin works itself THROUGH the clamp. I must be using a cheap clamp. The pin sticks out about 1/8 inch and bends the clamp just enough to create a crease that eventually breaks or the clamp loosens and the pin flies out. Thank goodness for a big magnet to find the pin in the...
Drive pin being thrown every two seconds. The drive pin broke two years ago. I replaced it and it held in just fine. I noticed that it was loose on one side but it engaged and worked fine. This year the pin was thrown out and now I have to use a hose clamp to keep it in for more than a few...
The pin connecting the pump shaft to the engine broke. Only half the pin broke. I am trying to push it out the other side but it does not budge. Any tips or suggestions on how to push it out?
Help - Wife is about to sell tractor! It seems my sediment bowl assembly is leeking just enough gas to make the garage reek of gas. I removed the sediment bowl and just trying to clean it up and tighten it up to stop leakage. The connection to the gas tank is loose. How do I tighten that. It...