• If you're having trouble logging into your account , you can Reset Password
Kirk Engines, Inc Cub Cadet Used Parts CADET CONNECTION Cub Cadet Specialties Cub Cadet Specialties

Bending 1/4 x 3 flat in a press brake

Help Support IH Cub Cadet Forum:

dschwandt

Well-known member
Joined
Mar 31, 2012
Messages
2,698
displayname
David Schwandt
With a spec of say 10" inches for an inside width for a finished piece with a 90* bend on each end, forming a shallow "U", where do I scribe the bend lines using a 2" width die?

I am assuming there must be some rule of thumb on how much to deduct from the desired inside width of the finished piece to allow for growth in the bending process.

Thanks Guys!!
 

mmasheris

Well-known member
Joined
Aug 8, 2006
Messages
707
displayname
Michael A.Masheris
If you don't care about out side dimension go by inside lines
 

Latest posts



Top