• FIRST AND LAST NAMES ARE REQUIRED WHEN REGISTERING

Bb36 gear box

IH Cub Cadet Tractor Forum

Help Support IH Cub Cadet Tractor Forum:

Jake Olsen

Well-known member
IHCC Supporter
Joined
Jun 8, 2021
Messages
195
Location
Utah
I had a set screw come loose on my snow blower and let the shaft slide and gears separate. My question is I have 3 tiller gear boxes and only 2 tillers and was wondering if those bevel gears are the same. Any thoughts would be great. Thank you.
 

jkoenig

Well-known member
Joined
Sep 14, 2002
Messages
1,274
displayname
Jim Koenig Halfway between Harvester, MO and Cadet, MO
I think tillers and snowblowers use different gear ratios. Good luck with your search. You could always count teeth.
 

digger

Administrator
Staff member
Administrator
Moderator
IHCC Sponsor
IHCC Supporter
Joined
Jun 22, 2002
Messages
15,965
Location
Park Rapids Mn.
displayname
Digger
I had a set screw come loose on my snow blower and let the shaft slide and gears separate. My question is I have 3 tiller gear boxes and only 2 tillers and was wondering if those bevel gears are the same. Any thoughts would be great. Thank you.
The gears should work from the tiller to the thrower unless the height of the gears is different. There are 2 styles of gears for both the throwers and tillers. The tiller gear will really spin the thrower though.
 

Jake Olsen

Well-known member
IHCC Supporter
Joined
Jun 8, 2021
Messages
195
Location
Utah
Well the tiller gears are the same tooth count but the bigger one is just a touch taller and I can’t tighten the cap or it hits the gear and locks it up. Found a 3 tab gearbox on eBay from bullpen so I’m waiting on that. Only One of my 3 tiller gearboxes is a 3 tab and it goes to my 105 which was my first old cub and still use lot.
 

Latest posts

Top