Archive through July 03, 2015

[jpatchett]

Doug M.,

Welcome.

When you turn the key is there a clicking sound? This would be the Starter Solenoid. No click - bad connections at SS, ignition switch, etc. Clicking sound - issue likely between SS and starter motor.

I would check for loose ground connections, at the battery, start solenoid, engine to block, etc. The connections at the battery often have issues with corrosion.

Wiring diagram:

https://www.ihcubcadet.com/cgi-bin/discus/board-auth.pl?lm=1291234823&file=/217125/217192.html

Jim

 

[masmith]

It has the correct solid pin. Not a roll pin. Replacing a hood hinge along with the fan has turned into moving the engine. Might as well take off the fenders, clean the hydro fins, and adjust the brakes too.

 

[jlspicer]

Everyone have a good and safe Fourth of July!

And enjoy watching some of these...........

 

[jbaker]

Everyone Have a Happy and safe 4th of July

 

[kostendorf]

Thank You Charlie, and have a safe and happy 4th.

 

[dmonasmith]

Thank y'all for the help. I found a bad ground connection on the solenoid so I have to go get a new one here in a bit. The ground pin snapped off when I was trying to tighten it down.

Also, I feel like I need a tag line like many of the folks on here. Let me know what you think of this one.

Ain't no feelin' like Cub mobilin'

 

[jbaker]

Doug, welcome,, good tag line

 

[mgwin]

Has anyone ever replaced the spring in the front PTO release handle? If so, what would be the chances of finding one?

I am referring to the 102,122 series.

 

[dmonasmith]

Well I am at a complete loss. When I was mowing on Thursday the tractor died. It cranked for a few times and then went dead. And since then I have replaced the battery, the ignition coil, the solenoid and the ignition switch and still nothing at all, no clicking-no grinding-no nothing. Any place I should check or what should I replace next?

 

[dmonasmith]

I really don't want to re-wire the whole thing but that may be next on the list.