• FIRST AND LAST NAMES ARE REQUIRED WHEN REGISTERING

Archive through July 03, 2010

Help Support IH Cub Cadet Forum:

bproctor

Well-known member
Joined
May 23, 2010
Messages
227
displayname
Bob G Proctor
Got my Haban sickle bar mower reinstalled on my 125. Works great! I was shocked at how good the bushings & bearings were. According to my manual its a 1968, 402-D.

Worked on the 123 and cleaned it up. I discovered th PO put (what looks like) auto trans fluid in the trans/diff. Its red, but when I removed the plate there was a distinct alcohol smell. Whats up with that?
 

apsmith

Member
Joined
Jun 20, 2010
Messages
18
displayname
Andrew Smith
I just got my head gasket for my 149. What are the torque specs for the head bolts?
 

bproctor

Well-known member
Joined
May 23, 2010
Messages
227
displayname
Bob G Proctor
Doesn't look 44 years old to me!

193440.jpg


But this is what was inside. Should I be worried?

193441.jpg
 

digger

Administrator
Staff member
Administrator
Moderator
IHCC Sponsor
Joined
Jun 22, 2002
Messages
15,747
Location
Park Rapids Mn.
displayname
Digger
Bob P.
At least it doesn't look like what I found in one of mine!
193443.jpg

193444.jpg

193445.jpg

Gotta love Hytran at work, and doing it's thing.
thumbsup_old.gif
 

mgonitzke

Well-known member
Joined
Aug 4, 2006
Messages
4,181
Location
Wichita, KS
displayname
Matt Gonitzke
Lucas-

Sort of. I have to either find or make a 1282 engine cradle (QL cradle isn't the same...the engine sits higher in an 82 series) and I have to move the wiring harness to the other side where it comes out in the front. I don't think the starter cable is going to reach.
 

ljones

Well-known member
Joined
Jan 15, 2010
Messages
737
Location
Kentucky
displayname
Lucas Jones
Matt, I plan to take a enginless 682 and drop a k-241aqs or a k-341aqs in it. Would a k-301aqs power it ok would it pull a 12inch plow?
 

mgonitzke

Well-known member
Joined
Aug 4, 2006
Messages
4,181
Location
Wichita, KS
displayname
Matt Gonitzke
Depends on the soil...up here, there's no way you'd pull a 12" plow with a 12 hp engine in a hydro. I've plowed with a 12 hp hydro once and it beat that poor thing to death with only a 10" plow...but that hard pull really made the engine run better. I'd say 14-16 hp would be better for that. A 10", on the other hand, wouldn't be much of a problem.
 

dtanner

Well-known member
Joined
Dec 8, 2005
Messages
6,544
displayname
Donald Tanner
Charlie "Digger" Proctor
I see that goop in my 147.It would freeze up there was so much crap in the rear end.I had to use my loader to get it from the storage shed so I could thaw and drain it. What a mess came out. I used brake clean and refilled it and had no problems after a fresh install of hytran.

Man Its to hot to do much here and I have so much to do.I will have to Waite till tonight to get some things done.
 
Top