Paul Lauria
Member
Thank you. Did you think my trunion repair is sufficient from looking at the pictures. I really really appreciate the help
-
This community needs YOUR help today. With the ever increasing fees of everything (server, software, domain, e-mail) , we need help. We need more Supporting Members, today. Please invest back into this community to help spread our love and knowledge of IH Cub Cadets. You get a lot of great new account perks including access to private forums. If you sign up for annual, I will ship a few IH Cub Cadet Forum decals too in addition to all the account perks you get. You can see what it looks like below.
Sign up here: https://www.ihcubcadet.com/account/upgrades
1650 Cub Cadet Hydrostatic Transmission Issues
- Thread starter Paul Lauria
- Start date
Help Support IH Cub Cadet Tractor Forum:
hydroharry
Well-known member
- Joined
- Jul 22, 2007
- Messages
- 4,377
- displayname
- Harry Bursell
We're waiting for a reply from David S., but to me your Trunion repair looks good. I am wondering if you replaced the 2 springs and buttons. The springs will loose tension over time and the buttons do wear which can cause erratic operation.
Paul Lauria
Member
Yes all of that hardware is new and has been replaced. I appreciate your time on this
Looks OK.
But I would like to have seen the 4 inside corners a bit more square.
But I would like to have seen the 4 inside corners a bit more square.
Paul Lauria
Member
Well I cleaned everything up and lightly oiled the washers etc. It is still not smooth. Any handle adjustment while moving causes the tractor to jerk.
Something is not right then and is binding somewhere.
Paul Lauria
Member
It’s very frustrating. I’m not sure what I’m doing wrong. Could the cam plate hole be worn out? There is no sliding where I put the shim washers but I can wiggle the plate from top a lot
