• This community needs YOUR help today. With the ever increasing fees of everything (server, software, domain, e-mail) , we need help. We need more Supporting Members, today. Please invest back into this community to help spread our love and knowledge of IH Cub Cadets. You get a lot of great new account perks including access to private forums. If you sign up for annual, I will ship a few IH Cub Cadet Forum decals too in addition to all the account perks you get. You can see what it looks like below.

    Sign up here: https://www.ihcubcadet.com/account/upgrades

1450 Transmission Assistance

IH Cub Cadet Tractor Forum

Help Support IH Cub Cadet Tractor Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I meant jb weld
I really appreciate the advice. I have the parts on the way and I have a craftsman mower that I have had for a few years that I use around the property. I have been waiting to find a tractor like this one for a while, so I am not going to work it until I fix it. I plan to own it and use it for as long as it or I will work so I am going to go ahead and fix all of it one piece at a time.
Also good to hear that I only have to take the seat and finder off to work on it. I really did not want to take the trans out.
 
Thanks everyone so much for the help! I was able to access the trunnion arm and weld the piece on so that the springs are now in place. I am able to drive around now which is awesome, but... Now when I run at full throttle it shutters very badly until I throttle back down to lowest idle. I have found there is a motor mount on the left side that is missing. I am going to take the one off the right and match it up at the store and try to put them both back in. I am hoping this solves my problem but if there are any other reasons for a shudder in the engine I would like to know. I can see my drive shaft (seeing that my tunnel cover is missing) and it is spinning very smooth. I have no problems at all at lower idle so I do not thing it is a carb issue but could be wrong. Has anyone else experienced a shudder in the engine at higher idles and it was something other than the motor mounts?
 
Oh, and to answer any questions that I saw discussed further up in this conversation, I was able to access the Control drive plate, Swashplate control arm, and Control arm by only removing the seat and the fender as a whole. It was a bit of a .... chore to get the tension rings off the arms, but I made it happen. I did have to get the special wrench to get them back on though. I was able to do the welding by placing a wet town all around everything that I had uncovered, and only letting the Swashplate control arm extend above it.
 

Latest posts

Back
Top