• This community needs YOUR help today. With the ever increasing fees of everything (server, software, domain, e-mail) , we need help. We need more Supporting Members, today. Please invest back into this community to help spread our love and knowledge of IH Cub Cadets. You get a lot of great new account perks including access to private forums. If you sign up for annual, I will ship a few IH Cub Cadet Forum decals too in addition to all the account perks you get. You can see what it looks like below.

    Sign up here: https://www.ihcubcadet.com/account/upgrades

782D journey

IH Cub Cadet Tractor Forum

Help Support IH Cub Cadet Tractor Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Finally, I had enough time to devote to finish this project after the parts arrived. It went together fairly well. While it was apart, I replaced the water pump belt, and the fan belt. The fan belt was the original one, and was ready to come apart.

The old worn driveshaft:

OLDSHAFT.jpg


New crank coupler bushing installed:

BUSHINGNEW.jpg


Completed driveshaft with mostly new parts:


NEWSHAFT.jpg


NOS Kubota alternator belt:

ALTBELT.jpg


New fan belt:

FANBELT.jpg
 
Did ya wipe out rear case and clean pickup screen, and clean vent and reseal dipstick ???
I have not touched the transaxle yet. This one is so smooth, responsive, and quiet, I kinda hate to delve into it. One thing that will make it difficult is the 3 point hitch. The hydro filter is an old one with the IH logo on it, so at minimum it should get a new filter.
 
Those rag joint bolts are WAY too tight. Tighten them until they just slightly start to deform. One pair of bolts looks too short too; might need to replace those so you will still have enough threads showing through the nut when they are tightened properly.
 
Finally, I had enough time to devote to finish this project after the parts arrived. It went together fairly well. While it was apart, I replaced the water pump belt, and the fan belt. The fan belt was the original one, and was ready to come apart.

The old worn driveshaft:

View attachment 152783

New crank coupler bushing installed:

View attachment 152784

Completed driveshaft with mostly new parts:


View attachment 152785

NOS Kubota alternator belt:

View attachment 152786

New fan belt:

View attachment 152787
You need to install a star washer under the three wire ground on front left upright radiator support and the rubber joints on driveshaft are too tight over squished !!! The rest look great 👍
 
Finally, I had enough time to devote to finish this project after the parts arrived. It went together fairly well. While it was apart, I replaced the water pump belt, and the fan belt. The fan belt was the original one, and was ready to come apart.

The old worn driveshaft:

View attachment 152783

New crank coupler bushing installed:

View attachment 152784

Completed driveshaft with mostly new parts:


View attachment 152785

NOS Kubota alternator belt:

View attachment 152786

New fan belt:

View attachment 152787
I’ve welded up a lot of those shafts and then tempered them !!!
 
Back
Top