Kirk Engines, Inc Cub Cadet Used Parts CADET CONNECTION Cub Cadet Specialties Cub Cadet Specialties

Joe Cullison's latest activity

Help Support IH Cub Cadet Forum:

  • J
    Joe Cullison replied to the thread 125 timing story.
    So where is the best place to purchase a gasket set? Thank you
  • J
    Joe Cullison replied to the thread 125 timing story.
    The points are opening at the start of the compression. Which is 90 degrees past the window. They do open just as the compression starts...
  • J
    Joe Cullison replied to the thread 125 timing story.
    Unless I'm missing something, If the plug is in and I turn the flywheel until I'm feeling good compression, then that should be within...
  • J
    Joe Cullison replied to the thread 125 timing story.
    Have not had time to look at it any more. The sight hole is on the starter/generator side about halfway up and level with the...
  • J
    Joe Cullison replied to the thread 125 timing story.
    Yes, that is the direction I am turning it. Clockwise it is. Everything I read said the S passes the timing mark before the T. The...
  • J
    Joe Cullison replied to the thread 125 timing story.
    Ok, I have a small update. I had a few minutes today so I drained the oil to get ready to remove the oil pan and have a look at the...
  • J
    Joe Cullison replied to the thread 125 timing story.
    I took a picture of the top of the engine. It does look to me like the piston is under where the plug is laying. If I am looking at...
    • 20210223_194829[1].jpg
  • J
    Joe Cullison replied to the thread 125 timing story.
    I will take a look and get back to you. Maybe it is the valve I'm seeing and not the piston. Thank you Joe
  • J
    Hello, my wife and bought a 125 with a tiller on it around 6 years ago. It has always been really hard to start. It was a battle to get...
Top