• This community needs YOUR help today. With the ever increasing fees of everything (server, software, domain, e-mail) , we need help. We need more Supporting Members, today. Please invest back into this community to help spread our love and knowledge of IH Cub Cadets. You get a lot of great new account perks including access to private forums. If you sign up for annual, I will ship a few IH Cub Cadet Forum decals too in addition to all the account perks you get. You can see what it looks like below.

    Sign up here: https://www.ihcubcadet.com/account/upgrades

Recent content by dwhipple

cc specialties
Advertise with us
cub cadet used parts
xtreme motor works
IH Cub Cadet Tractor Forum

Help Support IH Cub Cadet Tractor Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. D

    46" Mower Deck

    I have a 46" mower deck from a 1415 or a1420 Cub Cadet for sale. It will fit other models also. Just need to sharpen the blades and it is ready to use. Asking $150.00 O.B.O.
  2. D

    1250 Engine Trouble

    I did clean the carburetor and the fuel bowl and checked the fuel flow from the tank into another container and it was fine. Spark seems to be good also.
  3. D

    1250 Engine Trouble

    Ok guys, I'm having trouble with my 1250 K301AQS engine. I have replaced the coil, points and condenser. I have also removed the fuel filter and ran a fuel line from the tank directly to the carburetor, warmed the engine and readjusted the carburetor. I then started mowing my grass, mowed for...
  4. D

    Archive through April 20, 2019

    Carb has been cleaned and rebuilt, fuel filter is new and spark plug replaced. Vent hole in gas cap is clear also. I know the older "K Series" engines had issues with valves needing adjustment. Could this be my issue? Needs valve adjustment?
  5. D

    Archive through April 20, 2019

    Looking for a little help with a 1250 Quiet line Cub. The trouble is with the engine. I can start the engine engage the mower deck and let it sit in place and it will run fine but, I start mowing and after driving about 60 feet the engine will sputter then just shut down. I can restart the...
  6. D

    Wanted To Buy

    Looking for the manual lift helper springs for an IH 2 stage snow thrower model # 190-364-100 or ideas for a possible way to replace the spring assembly. Please email me any suggestions @ [email protected]. Thank You.
  7. D

    Archive through December 11, 2018

    Hi everyone. I have a Cub Cadet 1250 that I'm going to be replacing the contact points, condenser and the ignition coil on. I have seen where the Kohler coil has been replaced with a coil from Accel or MSD. Looking for some feedback as to weather it is possible to make the switch or not and what...
  8. D

    2206 Electrical Issues

    Hello everybody. I'm in need of some electrical schematics for a Cub Cadet 2206. What I'm looking for is any diagrams that show current flow in the different circuits of the electrical system. I'm working on one that starts and runs until you take your foot off the parking brake then it shuts...
  9. D

    Archive through September 03, 2015

    Hi Charlie, That's what it looks like. Is that the model 418 or 419 assembly? I'm looking for the bracket, main pulley and the idle pulley bracket for the 418 model assembly. If I can get the right parts to mount it and get it operational, I will post a few photos of it for you.
  10. D

    Archive through September 03, 2015

    Does anyone have the mounting bracket and pulleys in the attached photo for 190-364-100 Snow Thrower that fits a 1250 Cub Cadet? Please contact me via email at [email protected]
  11. D

    Archive through February 05, 2015

    Does anyone have or know of anyone who has a Cub Cadet 2 stage snow thrower model #190-364-100 for sale?
  12. D

    Archive through January 25, 2015

    Does anyone make a two stage snow thrower for a Cub Cadet 1250 or would it be possible to modify a 2 stage snow thrower for use on a 1250?
  13. D

    Archive through May 02, 2014

    Anyone have a good light switch for a 1250? Please email me with price. Thank You.
  14. D

    Archive through July 09, 2013

    I'm in need of a good used muffler foe a Cub Cadet 1250. Please email me pictures and price. Thank You.
  15. D

    Archive through August 24, 2011

    JUST IN TIME FOR FALL LEAF CLEANUP! Cub Cadet 1415 w/ a Kohler 14hp Magnum opossing twin cylinder engine, 38" deck w/ bagger attachment. Runs good. Transaxle has been serviced w/ new shift keys, new drive belt. Comes with 2 additional front tires on wheels. $ 500.00 Email me at [email protected]...
See more
Back
Top