• This community needs YOUR help today. With the ever increasing fees of everything (server, software, domain, e-mail) , we need help. We need more Supporting Members, today. Please invest back into this community to help spread our love and knowledge of IH Cub Cadets. You get a lot of great new account perks including access to private forums. If you sign up for annual, I will ship a few IH Cub Cadet Forum decals too in addition to all the account perks you get. You can see what it looks like below.

    Sign up here: https://www.ihcubcadet.com/account/upgrades

Search results

IH Cub Cadet Tractor Forum

Help Support IH Cub Cadet Tractor Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. T

    New Member - 2182

    Not too tough just get your multimeter out and see which wires go to the colored ones and mark them only takes an ohm meter to mstch
  2. T

    129 low power at full throttle

    Not sure of the torque but 30 sounds about right for most small engine heads. Could be wrong. But it 21 foot pounds on a lot of them. 30 inch pounds would be low.
  3. T

    Why won't my tractor run??????

    Never mind different fuel post
  4. T

    Why won't my tractor run??????

    And if you reread his post he says it starts running good then dies as it’s running out
  5. T

    Tractor For Sale Help: How much is my tractor worth?

    Well it’s not like the older ones that have some value. I sell used lawn tractors in my shop. And like was said. 1000$ would be to the right buyer. I flip those after I’ve gone thru them for 800-1100 but that one has some hours on it. So don’t give a warranty most of those will need a rebuild soon
  6. T

    Slow Cranking K241

    Won’t turn over faster than a S/G turns. If battery is hood and timing is tight they just don’t turn as fast as a dedicated starter. I think it’s just starting quicker cause you fixed issues
  7. T

    New Walbro Carb... Engine Still Running Rich

    It’s still fuel. Carb is not delivering good fuel and air mix. If the model doesn’t have adjustments it’s either not jetted correctly or and most likely the float is adjusted wrong. As was said their sll Chinese carbs do it is what it is. I rebuild or swap a couple hundred carbs s year and...
  8. T

    Stator magnets

    You can epoxy a full magnet back but I’m not so sure about a broken one. Might be best to just find a flywheel
  9. T

    Best ignition coil

    Thank you
  10. T

    Best ignition coil

    which coil from Harley?
  11. T

    Advise

    Of our sponsors who would have my wiring harness for my 71. Thanks
  12. T

    Steering wheel

    50/50 mix acetone and transmission fluid let work into the rusted joint. You can leave some tension on it with your puller if you want. Patience and then next day take a ball peen hammer and give it a few lite raps tighten up the puller. If after a few attempts this doesn’t work. Get the torch...
  13. T

    Narrow Frame vs. Wide Frame

    Ok. I was just confused
  14. T

    Narrow Frame vs. Wide Frame

    The 71 is a manual. That’s an odd nimber
  15. T

    1450 wiring question

    Where did you get your wiring harness
  16. T

    Generator/Starter ~ Test, Rewind/Replace

    Just had mine gone thru at an armature place here in Memphis like new 65$
Back
Top