I have told few people in here the same thing. I tried so many times rev it up. Back and forth on drive lever but nothing. I even had these lubed last summer. Going to.take out the hex bodies and see what going on. I post some pictures
I feel stupid to post this because I have helped tell people on here why and how to correct the free wheel mode.
Now everything I try, the pins are down flat.
I was working on my snow plower project all winter and had lever in free wheel. So I got the blower mounted and running great. But...
I have a cub 169. It does something similar. My battery full charge, I get a hard chattering solenoid when key is in start position. From the key mine goes to PTO limit switch. And the to clutch/brake limit. Then the signal goes to the solenoid. Did you check voltage through these two switches...
Thanks for the info and pictures I finally got mine to lock into the frame. It was very heavy doing it alone. But 2x4 helped get the correct height. Going to make a small pallet to store it on with exact height needed.
Thanks the pictures help so much especially the pic of the frame with no motor.. I see there is a nut tached to the frame, one side of mine must have ripped it off because I can feel o bolt head spinning there.
I have a 36 inch cub blower that came with my 169. I not see many post on the smaller blower just the 46 I think we're the numbers. I hope this one is wide enough to clear a path for the rear wheels. Does anyone know how QA-36A blower works? It is in great shape, no rust new decals. I hope it...
Has anyone had one these bolt head pins break off tractor frame. I like to see what this part looks like. The parts books so far just show the frame rail with the holes.
Prior owner has large square nut with a lock washer floating between the nut and frame seized to big bolt. Make mower deck...
Can I ask if anyone has a picture of the pin configuration the Mule drive slides onto. I looked in manuals in here but they just show the hole in the frame. I show a picture of what prior owner stuck in place. I like to put correct pin back in place. I. Try to remove the Hillbilly repairs and go...
Could I ask some of the negative about the blower? I have one for my 169 and want to try it this winter just to see how it works. Now my comment on plow. I have a old manual transmission ATV. It has a heavy blade and I am surprised what it can do in 3 feet of snow. And when it comes to wet heavy...
Here is my next hopefully quick project. This snow blower is a QA-36A it seems in great condition. It came with the tractor few years ago. For some reason they painted it red? Even has new decals. It has a mint condition manual for the blower. I can not believe how heavy this thing is, compared...
Someone in the past removed the headlights from my 169. They put what looks like a factory flat plate from another model cub. So I found these Led flat lights draw very little amps. They are amazing bright. I like to find a bulb in led that will go in the cub tail lights